Miner configuration

Setting up a miner on the VNISH firmware

Open the miner in the browser address bar and click Unlock
In the window that appears, enter the password. Default: admin

Go to the “Mining” tab
Open the “Pools” section and enter the stratums and workers of your pools. We recommend adding several different ones in case communication with one of the pools is lost.

Go to the “Cooling” tab
Set the target temperature (Recommendation: 65-70°C)

Go to the “Performance” tab
Select the overclocking profile (miner operating mode)

Go to the “Advanced” tab
Restart on low hashrate – 70 (when the hashrate drops by 30%, the miner will reboot)
In the “Other” section, enable the following options:
- Check domain balancing
- Check voltage setting
- Check chain integrity
- Continue mining after reboot
- Downgrade profile on error
Click Save and then Apply

In the “Overview” section, you can see the miner status and that autotuning has started. Autotuning takes up to 2 hours, and after completion, the status will change to Mining.